Users Guide

Auto-Negotiation, Speed, and Duplex Settings on Different Optics:
Command Mode 10GbaseT
module
10G SFP+
optics
1G SFP optics Copper SFP
- 1000baseT
Comments
speed 100 interface-
config
mode
Supported Not
supported(
Error
message is
thrown) (%
Error:
Speed 100
not
supported
on this
interface,
config
ignored Te
0/49)
Not
supported(Error
message is
thrown) (% Error:
Speed 100 not
supported on this
interface, config
ignored Te 0/49)
% Error:
Speed 100
not
supported
on this
interface,
speed auto interface-
config
mode
Supported Not
supported
Not supported Not
supported
Error
messages not
thrown
wherever it
says not
supported
speed 1000 interface-
config
mode
Supported Supported Supported Supported
speed 10000 interface-
config
mode
Supported Supported Not Supported Not
supported
Error
messages not
thrown
wherever it
says not
supported
negotiation
auto
interface-
config
mode
Supported Not
supported(
Should
some
error
message
be
thrown?)
Not supported Not
supported
Error
messages not
thrown
wherever it
says not
supported
duplex half interface-
config
mode
Supported CLI not
available
CLI not available Invalid Input
error- CLI
not available
duplex full interface-
config
mode
Supported CLI not
available
CLI not available Invalid Input
error-CLI
not available
Interfaces
125