Users Guide

Dell(conf)# exit
Dell#00:23:49: %STKUNIT0-M:CP %SYS-5-CONFIG_I: Configured from console
Dell# show vlan id 4
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P -
Primary,
C - Community, I - Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT
tagged, C - CMC tagged
NUM Status Description Q Ports
4 Active U Po1(Te 0/16)
T Po128(Te 0/33,39,51,56)
T Te 0/1-15,17-32
Dell#
VLAN Configuration on Physical Ports and Port-Channels
Unlike other Dell Networking OS platforms, IOA allows VLAN configurations on port and port-channel
levels. This allows you to assign VLANs to a port/port-channel.
NOTE: In PMUX mode, in order to avoid loops, only disjoint VLANs are allowed between the uplink
ports/uplink LAGs and uplink-to-uplink switching is disabled.
1. Initialize the port with configurations such as admin up, portmode, and switchport.
Dell#configure
Dell(conf)#int tengigabitethernet 0/1
Dell(conf-if-te-0/1)#no shutdown
Dell(conf-if-te-0/1)#portmode hybrid
Dell(conf-if-te-0/1)#switchport
2. Configure the tagged VLANs 10 through 15 and untagged VLAN 20 on this port.
Dell(conf-if-te-0/1)#vlan tagged 10-15
Dell(conf-if-te-0/1)#vlan untagged 20
Dell(conf-if-te-0/1)#
3. Show the running configurations on this port.
Dell(conf-if-te-0/1)#show config
!
interface TenGigabitEthernet 0/1
portmode hybrid
switchport
vlan tagged 10-15
vlan untagged 20
no shutdown
Dell(conf-if-te-0/1)#end
Dell#
4. Initialize the port-channel with configurations such as admin up, portmode, and switchport.
Dell#configure
Dell(conf)#int port-channel 128
112
Interfaces