Owner`s manual

236 | Uplink Failure Detection (UFD)
www.dell.com | support.dell.com
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 24-1. show running-config uplink-state-group Command Example
Related
Commands
show uplink-state-group
Displays status information on a specified uplink-state group or all groups.
Syntax
show uplink-state-group [group-id] [detail]
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
group-id
Displays the current configuration of all uplink-state groups or a specified
group. Valid group-id values are 1 to 16.
Version 8.3.17.0 Supported on M I/O Aggregator
FTOS#sho running-config uplink-state-group
!
uplink-state-group 1
downstream TenGigabitEthernet 0/1-32
downstream TenGigabitEthernet 1/1-32
upstream Port-channel 128
defer-timer 10
FTOS#
show uplink-state-group Displays status information on a specified uplink-state group or all groups.
group-id Displays status information on a specified uplink-state group or all
groups. Valid group-id values are 1 to 16.
detail Displays additional status information on the upstream and
downstream interfaces in each group
Version 8.3.17.0 Supported on M I/O Aggregator