Owner`s manual

Interfaces | 153
Figure 11-31. show vlan id Command Example
Figure 11-32. show vlan brief Command Example
Figure 11-33. Using a VLAN Name Example
Related
Commands
Status
Displays the word
Inactive for inactive VLANs and the word
Active for active VLANs.
Q
Displays G for GVRP tagged, M for member of a VLAN-Stack VLAN, T
for tagged interface, U (for untagged interface), x (uncapitalized x) for
Dot1x untagged, or
X (capitalized X) for Dot1x tagged.
Ports
Displays the type, slot, and port information. For the type, Po = port
channel,
Fo= fortygigabit ethernet, and Te = ten gigabit ethernet.
Table 11-10. show vlan Command Information
Column Heading Description
FTOS# show vlan id 40
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring
VLANs, P - Primary, C - Community, I - Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V
- VLT tagged
NUM Status Description Q Ports
1 Inactive a
FTOS#
FTOS#show vlan brief
VLAN Name STG MAC Aging IP Address
---- -------------------------------- ---- --------- ------------------
1 0 0 unassigned
2 0 0 unassigned
20 0 0 unassigned
1002 0 0 unassigned
FTOS#
FTOSconf)#interface vlan 222
FTOS(conf-if-vl-222)#name test
FTOS(conf-if-vl-222)#do show vlan name test
Codes: * - Default VLAN, G - GVRP VLANs
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack
NUM Status Description Q Ports
222 Inactive U TenGig 1/22
FTOS(conf-if-vl-222)#
FTOS#
interface vlan Configures a VLAN.