Owner`s manual

106 | Dynamic Host Configuration Protocol (DHCP)
www.dell.com | support.dell.com
ip address dhcp
Acquire an IP address dynamically on an interface from the DHCP server.
Syntax
ip address dhcp
To diable DHCP Client on an interface, use the no ip address dhcp command.
Command Mode
INTERFACE
Default
Enabled
Command
History
Usage
Information
In the M I/O Aggregator, the DHCP client is enabled only on the default vlan and management
interface 0/0. Use the ip address command to assign a static ip address that overwrites the
dynamically assigned IP address.
clear ip dhcp client statistics
Displays DHCP client statistics, including the number of DHCP messages sent and received on an
interface.
Syntax
clear ip dhcp client statistics {all | interface type slot/port}
Parameters
Command Mode
EXEC Privilege
Default
None.
Command
History
debug ip dhcp client events
Enable the display of log messages for the following events on DHCP client interfaces:
• IP address acquisition
• IP address release
• Renewal of IP address and lease time
• Release of an IP address
Syntax
debug ip dhcp client events [interface type slot/port]
Version 8.3.17.0 Supported on M I/O Aggregator
all
Clear DHCP client statistics on all DHCP client-enabled interfaces on the switch.
interface type slot/
port
Clear DHCP client statistics on the specified interface.
• For the management interface on the stack-unit, enter the keyword
managementethernet followed by slot/port information. The slot and port
range is 0.
• For a VLAN, enter the keyword vlan followed by a number from 1 to 4094.
Version 8.3.17.0 Supported on M I/O Aggregator