Deployment Guide

pattern pattern Enter the IPv4 data pattern. The range is from 0 to FFFF. The default is 0xABCD.
sweep-min-size Enter the minimum size of datagram in sweep range. The range is from 52 to 15359 bytes.
sweep-max-size Enter the maximum size of datagram in sweep range. The range is from 53 to 15359
bytes.
sweep-interval Enter the incremental value for sweep size. The range is from 1 to 15308 seconds.
ointerface Enter the outgoing interface for multicast packets. Enter the IP address in A.B.C.D format.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults See parameters above.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information When you enter the ping command without specifying an IP address (Extended Ping), you are prompted for a
target IP address, a repeat count, a datagram size (up to 1500 bytes), a timeout (in seconds), and for Extended
Commands. For information on the ICMP message codes that return from a ping command, refer to Internet
Control Message Protocol (ICMP) Message Types
.
Example (IPv4)
Dell#ping 172.31.1.255
Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 172.31.1.255, timeout is 2 seconds:
Reply to request 1 from 172.31.1.208 0 ms
Reply to request 1 from 172.31.1.216 0 ms
Reply to request 1 from 172.31.1.205 16 ms
::
Reply to request 5 from 172.31.1.209 0 ms
Reply to request 5 from 172.31.1.66 0 ms
Reply to request 5 from 172.31.1.87 0 ms
Dell#
reload
Reboot the Dell Networking OS.
Syntax
reload
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
Control and Monitoring 57