Deployment Guide

http-server
Disable / Enable the Blade I/O Manager Software.
Syntax
http-server blademgr
Parameters
blademgr Enter the keyword blademgr and specify the port for HTTP.
Defaults ENABLED
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11(0.0 ) Introduced on the Stomp IOA and MXL-IOA
Usage Information By default, the Blade I/O Manager is enabled and there is no entry in the running conguration. Using the
command no http-server blademgr, disables the Blade I/O Manager and also a “no http-server” entry is
made in the running conguration. To re-enable the Blade I/O Manager, use the command http-server
blademgr
which enables the feature and also removes the entry from the running conguration. On reload, if the
system detects a “no http-server” entry in the start-cong, the feature will be disabled.
NOTE: Please ensure to save and reload the conguration for the changes to take eect.
ip telnet server enable
Enable the Telnet server on the switch.
Syntax
ip telnet server enable
To disable the Telnet server, use the no ip telnet server enable command.
Defaults Enabled
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
54 Control and Monitoring