Deployment Guide

debug cpu-trac-stats

Enable the collection of computer processor unit (CPU) trac statistics.

Syntax

debug cpu-traffic-stats

Defaults Disabled

Command Modes EXEC Privilege

Supported Modes All Modes

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.4(0.0) Supported on the FN I/O Aggregator.

8.3.17.0 Supported on the M I/O Aggregator.

Usage Information This command enables (and disables) the collection of CPU trac statistics from the time this command is

executed (not from system boot). However, excessive trac a CPU receives automatically triggers (turn on) the

collection of CPU trac statics.

To view the trac statistics, use the show cpu-traffic-stats command.

If the CPU receives excessive trac, trac is rate controlled.

NOTE: You must enable this command before the show cpu-traffic-stats command displays

trac statistics. Dell Networking recommends disabling debugging (no debug cpu-traffic-

stats

) after troubleshooting is complete.

Related Commands show cpu-trac-stats— displays the cpu trac statistics.

debug ifm trace-ags

Turn on the IFM internal trace-ags.

Syntax

debug ifm trace-flags trace-flags

To disable this command, use the no debug ifm trace-flags command.

Parameters

trace-ags Enter a hexadecimal number representing the trace-ag.

Defaults None