Deployment Guide

IOA Reg Request sent: 2
IOA Reg Request rcvd: 2
IOA Reg Response sent: 2
IOA Reg Response rcvd: 1
VLT NDP Statistics
--------------------
NDP NA VLT Tunnel Pkts sent:0
NDP NA VLT Tunnel Pkts Rcvd:0
NDP NA Non-VLT Tunnel Pkts sent:0
NDP NA Non-VLT Tunnel Pkts Rcvd:0
Ndp-sync Pkts Sent:0
Ndp-sync Pkts Rcvd:0
Ndp Reg Request sent:2
Ndp Reg Request rcvd:1
VLT multicast not enabled
stack-unit iom-mode
Set the switch operating mode to VLT mode.
Syntax
stack-unit <unit-number> iom-mode vlt
Parameters
unit number <0-5> Enter the number of the member stack unit. The range is from 0 to 5. The default is 0.
vlt Enable virtual link trunking mode.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
Usage Information This command resets the operating mode to VLT. You must reboot the switch after using this command.
system-mac
Recongure the default MAC address for the domain.
Syntax
system-mac mac-address
Parameters
mac-address Enter the system MAC address for the VLT domain.
Defaults Not congured.
Command Modes VLT DOMAIN
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
426 Virtual Link Trunking (VLT)