Deployment Guide
• Port channel: port-channel {1-512 | port-channel-range}
Where port-range and port-channel-range specify a range of ports separated
by a dash (-) and/or individual ports/port channels in any order; for example:
gigabitethernet 1/1-2,5,9,11-12 port-channel 1-3,5. A comma is
required to separate each port and port-range entry.
Defaults none
Command Modes UPLINK-STATE-GROUP
Supported Modes Programmable-Mux (PMUX)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information
You can assign physical port or port-channel interfaces to an uplink-state group.
You can assign an interface to only one uplink-state group. Congure each interface assigned to an uplink-state
group as either an upstream or downstream interface, but not both.
You can assign individual member ports of a port channel to the group. An uplink-state group can contain either the
member ports of a port channel or the port channel itself, but not both.
Example
Dell(conf-uplink-state-group-16)# upstream gigabitethernet 1/10-15
Dell(conf-uplink-state-group-16)#
Related Commands
• downstream — assigns a port or port-channel to the uplink-state group as a downstream interface.
418 Uplink Failure Detection (UFD)