Deployment Guide

To delete an uplink-state group, enter the no uplink-state-group group-id command.
Parameters
group-id Enter the ID number of an uplink-state group. The range is from 1 to 16.
Defaults none
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
Usage Information
After you enter the command, to assign upstream and downstream interfaces to the group, enter Uplink-State-
Group Conguration mode.
An uplink-state group is considered to be operationally up if at least one upstream interface in the group is in the
Link-Up state.
An uplink-state group is considered to be operationally down if no upstream interfaces in the group are in the Link-
Up state. No uplink-state tracking is performed when a group is disabled or in an operationally down state.
To disable upstream-link tracking without deleting the uplink-state group, use the no enable command in uplink-
state-group conguration mode.
Example
Dell(conf)#uplink-state-group 16
Dell(conf)#
02:23:17: %RPM0-P:CP %IFMGR-5-ASTATE_UP: Changed uplink state group Admin
state to up: Group 16
Related Commands
• show running-cong uplink-state-group — displays the current conguration of one or more uplink-state
groups.
• show uplink-state-group — displays the status information on a specied uplink-state group or all groups.
upstream
Assign a port or port-channel to the uplink-state group as an upstream interface.
Syntax
upstream interface
To delete an uplink-state group, use the no upstream interface command.
Parameters
interface Enter one of the following interface types:
• Fast Ethernet: fastethernet {slot/port | slot/port-range}
• 1 Gigabit Ethernet: gigabitethernet {slot/port | slot/port-range}
• 10 Gigabit Ethernet: tengigabitethernet {slot/port | slot/port-
range}
• 40 Gigabit Ethernet: fortyGigE {slot/port | slot/port-range}
Uplink Failure Detection (UFD) 417