Deployment Guide

Version Description
9.2(0.0) Supported on the M I/O Aggregator.
show running-cong uplink-state-group
Display the current conguration of one or more uplink-state groups.
Syntax
show running-config uplink-state-group [group-id]
Parameters
group-id Displays the current conguration of all uplink-state groups or a specied group. The valid
group-id values are from 1 to 16.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
Example
Dell#show running-config uplink-state-group
!
no enable
uplink state track 1
downstream TengigabitEthernet 0/2,4,6,11
upstream TengigabitEthernet 0/8, 12
upstream PortChannel 1
!
uplink state track 2
downstream TengigabitEthernet 0/1,3,5
upstream TengigabitEthernet 0/9,10
Related Commands
• show uplink-state-group — displays the status information on a specied uplink-state group or all groups.
• uplink-state-group — creates an uplink-state group and enables the tracking of upstream links.
show uplink-state-group
Display status information on a specied uplink-state group or all groups.
Syntax
show uplink-state-group [group-id] [detail]
Parameters
group-id Displays status information on a specied uplink-state group or all groups. The valid
group-id values are from 1 to 16.
detail Displays additional status information on the upstream and downstream interfaces in each
group
Uplink Failure Detection (UFD) 415