Deployment Guide

programmable-mux Enable programmable multiplex mode.
stack Enable stack mode.
standalone Enable stand-alone mode.
vlt Enable virtual link trunking mode.
Defaults standalone
Command Modes
• CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.6.(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information This command is supported on the M I/O, FN410S, and FN410T Aggregators.
Example
Dell(conf)#stack-unit 0 iom-mode stack
% You are about to stack your IOA module, please reload the IOA
and then plug in the stacking cable for the changes to take effect.
Dell(conf)#
Dell#
Related Commands
reload— Reboots the operating system.
show system— displays the current status of all stack members or a specic member.
stack-unit iom-mode uplink-speed
Specify the uplink speed of the member interfaces in a LAG bundle for the Aggregator that operates in standalone, stacking, or VLT mode
to be 40 GbE. By default, the uplink speed of the LAG bundle is set as 10 GbE.
Syntax
stack-unit unit-number iom-mode {stack | standalone | vlt} uplink-speed 40G
To restore the default uplink speed of the LAG bundle, which is 10 GbE, use the stack-unit unit-number
iom-mode {stack | standalone | vlt} command.
Parameters
unit number <0-5> Enter the number of the member stack unit. The range is from 0 to 5.
iom-mode Denotes the operating mode of the I/O Aggregator.
stack Specify that the uplink speed of the member interfaces in a LAG bundle applies for the
Aggregator in stacking mode
standalone Specify that the uplink speed of the member interfaces in a LAG bundle applies for the
Aggregator in standalone mode
vlt Specify that the uplink speed of the member interfaces in a LAG bundle applies for the
Aggregator in VLT mode
uplink-speed 40G Set the uplink speed of the member or child interfaces of the LAG bundle to function at
40 Gigabit Ethernet per second
Stacking Commands 371