Deployment Guide

Parameter
Unit number The unit number ranges from 0 to 5.
Defaults None
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.6.(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
This command is supported on the M I/O, FN410S, and FN410T Aggregators.
This command is used to reset the stack-unit. The master unit can also be power cycled using this command.
reset stack-unit
Reset any designated stack member except the management unit (master unit).
Syntax
reset stack-unit 0–5 hard
Parameters
0–5 Enter the stack member unit identier of the stack member to reset.
hard Reset the stack unit if the unit is in a problem state.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.6.(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
This command is supported on the M I/O, FN410S, and FN410T Aggregators
Resetting the management unit is not allowed and an error message displays if you try to do so. Resetting is a soft
reboot, including ushing the forwarding tables.
You can run this command directly on the stack standby unit (Standby Master) to reset the standby. You cannot
reset any other unit from the standby unit
Example
Dell#show system brief
Stack MAC : 00:1e:c9:f1:00:9b
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
---------------------------------------------------------------------------------
---
0 Management online I/O-Aggregator I/O-Aggregator 8-3-17-46 56
1 Standby online I/O-Aggregator I/O-Aggregator 8-3-17-46 56
2 Member not present
3 Member not present
4 Member not present
5 Member not present
Dell#
366 Stacking Commands