Deployment Guide

NOTE: For version 1 and version 2c security models, this string represents the
name of the SNMP community. The string can be set using this command;
however, Dell Networking OS recommends setting the community string
using the snmp-server community command before executing this
command. For version 3 security model, this string is the USM user security
name.
udp-port port-
number
(OPTIONAL) Enter the keywords udp-port followed by the port number of the remote
host to use. The range is from 0 to 65535. The default is 162.
notication-type (OPTIONAL) Enter one of the following keywords for the type of trap to be sent to the
host:
• bgp — Enable BGP state change traps.
• ecfm — Enable ECFM state change traps.
•
entity — Enable entity change traps.
• envmon — Enable SNMP environmental monitor traps.
• eoam — Enable EOAM state change traps
• ets — Enable ets traps
• fips — Enable FIP Snooping state change traps
• lacp — Enable LACP state change traps.
• isis — Enable ISIS adjacency change traps
• pfc — Enable pfc traps
• snmp — Enable SNMP trap
• stp — Enable 802.1d state change traps
• vlt — Enable VLT traps
• vrrp — Enable VRRP state change traps
• xstp — Enable 802.1s, 802.1w, and PVST+ state change traps
The default is all trap types are sent to host.
Defaults
As above.
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0)
Introduced on the M I/O Aggregator.
Usage Information
In order to congure the router to send SNMP notications, enter at least one snmp-server host command.
If you enter the command with no keywords, all trap types are enabled for the host. If you do not enter an snmp-
server host
command, no notications are sent.
Simple Network Management Protocol (SNMP) and Syslog 361