Deployment Guide

ip radius source-interface
Specify an interface’s IP address as the source IP address for RADIUS connections.
Syntax
ip radius source-interface interface
To delete a source interface, use the no ip radius source-interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a 100/1000 Ethernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the
slot/port information.
•
For Loopback interfaces, enter the keyword loopback then a number from zero (0)
to 16838.
• For the Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a ten-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.3.(0.0) Supported on the M I/O Aggregator.
ip tacacs source-interface
Specify an interface’s IP address as the source IP address for TACACS+ connections.
Syntax
ip tacacs source-interface interface
To delete a source interface, use the no ip tacacs source-interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a 100/1000 Ethernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the
slot/port information.
•
For Loopback interfaces, enter the keyword loopback then a number from zero (0)
to 16838.
Security 331