Deployment Guide

dot1p Queue Number
7 7
Defaults none
Command Modes INTERFACE
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The dot1p-priority command changes the priority of incoming trac on the interface. The system places
trac marked with a priority in the correct queue and processes that trac according to its queue.
When you set the priority for a port channel, the physical interfaces assigned to the port channel are congured
with the same value. You cannot assign the dot1p-priority command to individual interfaces in a port
channel.
policy-aggregate
Allow an aggregate method of conguring per-port QoS via policy maps. An aggregate QoS policy is part of the policy map (input/output)
applied on an interface.
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate conguration, use the no policy-aggregate qos-policy-name command.
Parameters
qos-policy-name Enter the name of the policy map in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION (policy-map-input and policy-map-output)
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Aggregate input/output QoS policy applies to all the port ingoing/outgoing trac. Aggregate input/output QoS
policy can coexist with per queue input/output QoS policies.
Quality of Service (QoS) 309