Deployment Guide

Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
mac-address-table station-move refresh-arp
Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs due to a topology change.
Syntax
[no] mac-address-table station-move refresh-arp
Defaults Enabled
Command Modes CONFIGURATION
Supported Modes
Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Modied the default option from none to Enabled. Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information For details about using this command, refer to the “NIC Teaming” section of the Layer 2 chapter in the Dell
Networking OS Conguration Guide.
show cam mac stack-unit
Display the content addressable memory (CAM) size and the portions allocated for MAC addresses and for MAC ACLs.
Syntax
show cam mac stack-unit unit_number port-set port-pipe count [vlan vlan-id]
[interface interface]
Parameters
stack-unit
unit_number
(REQUIRED) Enter the keyword stack-unit followed by a stack member number to
select the stack unit for which to gather information. The range is 0 to 5.
port-set port-pipe (REQUIRED) Enter the keywords port-set followed by a Port-Pipe number to select
the Port-Pipe for which to gather information. The range is 0.
address mac-addr (OPTIONAL) Enter the keyword address followed by a MAC address in the
nn:nn:nn:nn:nn:nn format to display information on that MAC address.
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC addresses learned
dynamically by the switch.
static (OPTIONAL) Enter the keyword static to display only those MAC address specically
congured on the switch.
Layer 2 275