Deployment Guide

Related Commands show vlan – displays the VLAN conguration.
mac-address-table aging-time
Specify an aging time for MAC addresses to remove from the MAC address table.
Syntax
mac-address-table aging-time seconds
To delete the congured aging time, use the no mac-address-table aging-time seconds command.
Parameters
seconds Enter either zero (0) or a number as the number of seconds before MAC addresses are
relearned. To disable aging of the MAC address table, enter 0. The range is from 10 to
1000000. The default is 1800 seconds.
Defaults 1800 seconds
Command Modes CONFIGURATION
Supported Modes
Programmable-Mux (PMUX)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
mac-address-table static
Associate specic MAC or hardware addresses to an interface and virtual local area networks (VLANs).
Syntax
mac-address-table static mac-address output interface vlan vlan-id
To remove a MAC address, use the no mac-address-table static mac-address output
interface vlan vlan-id command.
Parameters
mac-address Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn format.
output interface Enter the keyword output then one of the following interfaces for which trac is
forwarded:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
vlan vlan-id Enter the keyword vlan then a VLAN ID number from 1 to 4094.
Defaults Not congured.
274 Layer 2