Deployment Guide

To delete all routes matching a certain route, use the no ip route destination mask command.
Parameters
destination Enter the IP address in dotted decimal format of the destination device.
mask Enter the mask in the slash prex format (/x) of the destination device’s IP address.
ip-address Enter the IP address in dotted decimal format of the forwarding router.
interface
Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number from 1 to 4094.
distance (OPTIONAL) Enter a number as the distance metric assigned to the route. The range is
from 1 to 255.
permanent (OPTIONAL) Enter the keyword permanent to specify the route is not removed, even if
the interface assigned to that route goes down. The route must be up initially to install it
in the routing table.
If you disable the interface with an IP address associated with the keyword permanent,
the route disappears from the routing table.
tag tag-value (OPTIONAL) Enter the keyword tag followed by a number to assign to the route. The
range is from 1 to 4294967295.
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information Using the following example of a static route: ip route 33.33.33.0 /24 tengigabitethernet 0/0 172.31.5.43
• The software installs a next hop that is not on the directly connected subnet but which recursively resolves to
a next hop on the interface’s congured subnet. In the example, if gig 0/0 has an ip address on subnet 2.2.2.0
and if 172.31.5.43 recursively resolves to 2.2.2.0, Dell Networking OS installs the static route.
• When the interface goes down, Dell Networking OS withdraws the route.
• When the interface comes up, Dell Networking OS re-installs the route.
• When recursive resolution is “broken,” Dell Networking OS withdraws the route.
• When recursive resolution is satised, Dell Networking OS re-installs the route.
Related Commands show ip route— views the switch routing table.
management route
Congure a static route that points to the Management interface or a forwarding router.
Syntax
management route {ipv4-address}/mask{forwarding-router-address |
managementethernet}
IPv4 Routing 239