Deployment Guide

00:12:42 : %RELAY-I-BOOTREPLY: Forwarded BOOTREPLY for 00:60:CF:20:7B:8C to
113.3.3.254
FTOS#
debug ip icmp
View information on the internal control message protocol (ICMP).
Syntax
debug ip icmp [interface] [count value]
To disable debugging, use the no debug ip icmp command.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For the management interface, enter the keyword ManagementEthernet then the
slot/port information. The slot range is 0 and the port range is 0.
• For a 10 Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
•
For VLAN, enter the keyword vlan then by a number from 1 to 4094.
count value (OPTIONAL) Enter the keywords count then the count value. The ranges from 1 to
65534. The default is Innity.
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
To stop packets from ooding the user terminal when debugging is turned on, use the count option.
Example
ICMP: echo request rcvd from src 40.40.40.40
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: echo request sent to dst 40.40.40.40
ICMP: echo request rcvd from src 40.40.40.40
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: echo request sent to dst 40.40.40.40:
ip route
Assign a static route to the switch.
Syntax
ip route destination mask {ip-address | interface [ip-address]}[distance]
[permanent][tag tag-value]
To delete a specic static route, use the no ip route destination mask {address | interface
[ip-address]} command.
238 IPv4 Routing