Deployment Guide

Example
Dell(conf-mon-sess-1)# source tengigabitethernet 0/1 destination
tengigabitethernet 0/45 direction rx
Dell(conf-mon-sess-1)#
Dell(conf-mon-sess-1)#do show monitor session
SessID Source Destination Dir Mode Source IP Dest IP
------ ------ ----------- --- ---- --------- --------
1 Te 0/1 Te 0/45 rx Port N/A N/A
Dell(conf-mon-sess-1)#
speed (for 1000/10000 interfaces)
Set the speed for 1000/10000 interfaces. Both sides of a link must be set to the same speed (1000/10000) or to auto or the link may not
come up.
Syntax
speed {1000 | 10000 | auto}
To return to the default setting, use the no speed {1000 | 10000 |auto} command.
Parameters
1000 Enter the keyword 1000 to set the interface’s speed to 1000 Mb/s.
10000 Enter the keyword 10000 to set the interface’s speed to 10000 Mb/s. Auto-negotiation is
enabled.
auto Enter the keyword auto to set the interface to auto-negotiate its speed. Auto-
negotiation is enabled. For more information, refer to name.
Defaults auto
Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
9.10(0.0) Added support for fanned–out 1 Gigabit SFP port.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
This command is found on the 1000/10000 Base-T Ethernet interfaces.
When you enable auto, the system performs and automatic discovery to determine the optics installed and
congure the appropriate speed.
When you congure a speed for the 1000/10000 interface, conrm the negotiation auto command setting.
Both sides of the link must should have auto-negotiation either enabled or disabled. For speed settings of 1000 or
auto, the software sets the link to auto-negotiation and you cannot change that setting.
If you use an active optical cable (AOC), you can convert the QSFP+ port to a 10 Gigabit SFP+ port or 1 Gigabit
SFP port. You can use the speed command to enable the required speed.
Related Commands
negotiation auto — enables or disables auto-negotiation on an interface.
230 Interfaces