Deployment Guide
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information This last-member-query-interval is also the interval between successive Group-Specic Query messages. To
change the last-member-query interval, use this command.
ip igmp snooping mrouter
Statically congure a VLAN member port as a multicast router interface.
Syntax
ip igmp snooping mrouter interface interface
To delete a specic multicast router interface, use the no igmp snooping mrouter interface
interface command.
Parameters
interface interface Enter the following keywords and slot/port or number information:
• For a 100/1000 Ethernet interface, enter the keyword gigabitethernet followed
by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet followed
by the slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a Port Channel interface, enter the keywords port-channel then a number.
Defaults Not congured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Supported Modes Programmable-Mux (PMUX)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information Dell Networking OS provides the capability of statically conguring the interface to which a multicast router is
attached. To congure a static connection to the multicast router, enter the ip igmp snooping mrouter
interface command in the VLAN context. The interface to the router must be a part of the VLAN where you
are entering the command.
Internet Group Management Protocol (IGMP) 187