Deployment Guide
Usage Information
FIP keepalive (FKA) messaging is used to detect if other FCoE devices are reachable.
To remove FIP keepalive monitoring from an FCoE map, enter the no keepalive command.
Related Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between servers
and a SAN fabric.
show fc switch
Display the switch conguration for Fibre Channel capability.
M I/O Aggregator with the FC Flex IO module
Syntax
show fc switch
Parameters None
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.7(0.0) Introduced on the M I/O Aggregator.
Usage Information
The following table describes the show fc switch output shown in the following example.
Switch Mode Fibre Channel mode of operation of an Aggregator.
Switch WWN Factory-assigned worldwide node (WWN) name of the Aggregator. The M I/O
Aggregator WWN name is not user-congurable.
Example
Dell(conf)#do show fc switch
Switch Mode : NPG
Switch WWN : 10:00:aa:00:00:00:00:ac
Dell(conf)#
show fcoe-map
Display the Fibre Channel and FCoE conguration parameters in FCoE maps.
M I/O Aggregator with the FC Flex IO module
Syntax
show fcoe-map [brief | map-name]
150 FC Flex IO Modules