Deployment Guide

In each FCoE map, the fabric ID, FC-MAP value, and FCoE VLAN parameters must be unique. Use one FCoE map
to access one SAN fabric. You cannot use the same FCoE map to access dierent fabrics.
To remove an FCoE map from an Ethernet interface, enter the no fcoe-map map-name command in Interface
conguration mode.
Related Commands
show fcoe-map— displays the Fibre Channel and FCoE conguration parameters in FCoE maps.
fka-adv-period
In an FCoE map, congure the time interval used to transmit FIP keepalive (FKA) advertisements.
M I/O Aggregator with the FC Flex IO module
Syntax
fka-adv-period seconds
Parameters
seconds Enter the time period (in seconds) used to send FIP keepalive messages to peer devices.
The range is from 8 to 90 seconds.
Defaults 8 seconds
Command Modes FCOE MAP
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO
module.
Usage Information
To delete the FIP keepalive time period from an FCoE map, enter the no fka-adv-erpiod command.
Related Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between servers
and a SAN fabric.
interface vlan (NPIV proxy gateway)
Create a dedicated VLAN to be used to send and receive Fibre Channel trac over FCoE links between servers and a fabric over an M I/O
Aggregator with the PMUX module NPIV proxy gateway.
M I/O Aggregator with the FC Flex IO module
Syntax
interface vlan vlan-id
Parameters
vlan-id Enter a number as the VLAN Identier. The range is 1 to 4094.
148 FC Flex IO Modules