Deployment Guide

Priority# Bandwidth TSA
0 13% ETS
1 13% ETS
2 13% ETS
3 13% ETS
4 12% ETS
5 12% ETS
6 12% ETS
7 12% ETS
Oper status is init
ETS DCBX Oper status is Down
Reason: Port Shutdown
State Machine Type is Asymmetric
Conf TLV Tx Status is enabled
Reco TLV Tx Status is enabled
0 Input Conf TLV Pkts, 0 Output Conf TLV Pkts, 0 Error Conf TLV Pkts
0 Input Traffic Class TLV Pkts, 0 Output Traffic Class TLV Pkts, 0 Error
Traffic Class
TLV Pkts
show interface pfc
Displays the PFC conguration applied to ingress trac on an interface, including priorities and link delay.
Syntax
show interface port-type slot/port pfc {summary | detail}
Parameters
port-type slot/ port
pfc
Enter the port-type slot and port PFC information.
{summary | detail} Enter the keyword summary for a summary list of results or enter the keyword detail
for a full list of results.
NOTE: This command also enables you to view information corresponding to a range of ports.
• You can specify multiple ports as slot/port-range. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show interfaces
interface-type 1/1 - 4.
Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to display the interface congurations
corresponding to a range of ports.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To clear the PFC TLV counters, use the clear pfc counters interface port-type slot/port
command.
The following describes the show interface pfc summary command shown in the following example.
Data Center Bridging (DCB) 129