Administrator Guide

Output 34.00 Mbits/sec, 12314 packets/sec, 0.36% of line-rate

Time since last interface status change: 00:13:57

Interface Range

An interface range is a set of interfaces to which other commands may be applied, and may be created if there is at least one valid

interface within the range. Bulk conguration excludes from conguring any non-existing interfaces from an interface range. A

default VLAN may be congured only if the interface range being congured consists of only VLAN ports.

The interface range command allows you to create an interface range allowing other commands to be applied to that range of

interfaces.

The interface range prompt oers the interface (with slot and port information) for valid interfaces. The maximum size of an

interface range prompt is 32. If the prompt size exceeds this maximum, it displays (...) at the end of the output.

NOTE: Non-existing interfaces are excluded from interface range prompt.

NOTE: When creating an interface range, interfaces appear in the order they were entered and are not sorted.

To display all interfaces that have been validated under the interface range context, use the show range in Interface Range

mode.

To display the running conguration only for interfaces that are part of interface range, use the show configuration command

in Interface Range mode.

Bulk Conguration Examples

The following are examples of using the interface range command for bulk conguration:

• Create a Single-Range

• Create a Multiple-Range

• Exclude a Smaller Port Range

• Overlap Port Ranges

• Commas

Create a Single-Range

Creating a Single-Range Bulk Conguration

Dell(conf)# interface range tengigabitethernet 0/1 - 23

Dell(conf-if-range-te-0/1-23)# no shutdown

Dell(conf-if-range-te-0/1-23)#

Create a Multiple-Range

Creating a Multiple-Range Prompt

Dell(conf)#interface range tengigabitethernet 0/5 - 10 , tengigabitethernet 0/1 , vlan

Dell(conf-if-range-te-0/5-10,te-0/1,vl-1)#

Exclude a Smaller Port Range

If the interface range has multiple port ranges, the smaller port range is excluded from the prompt.

Interface Range Prompt Excluding a Smaller Port Range

Dell(conf)#interface range tengigabitethernet 2/0 - 23 , tengigab 2/1 - 10

Dell(conf-if-range-te-2/0-23)#

Interfaces