Administrator Guide

I - Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged, C - CMC
tagged
NUM Status Description Q Ports
2 Active U Po1(Te 0/7,18)
T Po128(Te 0/50-51)
T Te 1/7
Dell(conf-if-te-1/7)
Except for hybrid ports, only a tagged interface can be a member of multiple VLANs. You can assign hybrid ports to two VLANs if
the port is untagged in one VLAN and tagged in all others.
NOTE: When you remove a tagged interface from a VLAN (using the no vlan tagged command), it remains tagged
only if it is a tagged interface in another VLAN. If you remove the tagged interface from the only VLAN to which it
belongs, the interface is placed in the default VLAN as an untagged interface.
Adding an Interface to an Untagged VLAN
To move an untagged interfaces from the default VLAN to another VLAN, use the vlan untagged command as shown in the
below gure.
Dell(conf)# interface tengigabit 0/16
Dell(conf-if-te-0/16)# vlan untagged 4
Dell(conf-if-te-0/16)# exit
Dell(conf)# exit
Dell#00:23:49: %STKUNIT0-M:CP %SYS-5-CONFIG_I: Configured from console
Dell# show vlan id 4
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P - Primary,
C - Community, I - Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged, C - CMC
tagged
NUM Status Description Q Ports
4 Active U Po1(Te 0/16)
T Po128(Te 0/33,39,51,56)
T Te 0/1-15,17-32
Dell#
VLAN Conguration on Physical Ports and Port-Channels
Unlike other Dell Networking OS platforms, IOA allows VLAN congurations on port and port-channel levels. This allows you to
assign VLANs to a port/port-channel.
NOTE: In PMUX mode, in order to avoid loops, only disjoint VLANs are allowed between the uplink ports/uplink LAGs and
uplink-to-uplink switching is disabled.
1. Initialize the port with congurations such as admin up, portmode, and switchport.
Dell#configure
Dell(conf)#int tengigabitethernet 0/1
Dell(conf-if-te-0/1)#no shutdown
Interfaces
91