Administrator Guide

After FIP packets are exchanged between the ENode and the switch, a FIP snooping session is established. ACLS are dynamically

generated for FIP snooping on the FIP snooping bridge/switch.

Debugging FIP Snooping

To enable debug messages for FIP snooping events, enter the debug fip-snooping command..

Task Command Command Mode

Enable FIP snooping debugging on for all or a specied

event type, where:

all enables all debugging options.

acl enables debugging only for ACL-specic events.

error enables debugging only for error conditions.

ifm enables debugging only for IFM events.

info enables debugging only for information events.

ipc enables debugging only for IPC events.

rx enables debugging only for incoming packet trac.

debug fip-snooping [all |

acl | error | ifm | info |

ipc | rx]

EXEC PRIVILEGE

To turn o debugging event messages, enter the no debug fip-snooping command.

FIP Snooping