Administrator Guide

--------------------
PG:0 TSA:ETS BW:30 PFC:OFF
Priorities:0 1 2 5 6 7
PG:1 TSA:ETS BW:30 PFC:OFF
Priorities:4
PG:2 TSA:ETS BW:40 PFC:ON
Priorities:3
Default FCoE map
Dell(conf)#do show fcoe-map
Fabric Name SAN_FABRIC
Fabric Id 1002
Vlan Id 1002
Vlan priority 3
FC-MAP 0efc00
FKA-ADV-Period 8
Fcf Priority 128
Config-State ACTIVE
Oper-State UP
Members
Fc 0/9
Te 0/4
DCB_MAP_PFC_OFF
Dell(conf)#do show qos dcb-map DCB_MAP_PFC_OFF
-----------------------
State :In-Progress
PfcMode:OFF
--------------------
Dell(conf)#
Enabling Fibre Channel Capability on the Switch
Enable the Fibre Channel capability on an Aggregator that you want to congure as an NPG for the Fibre Channel protocol. When
you enable Fibre Channel capability, FCoE transit with FIP snooping is automatically enabled on all VLANs on the switch, using the
default FCoE transit settings.
Task
Command Command Mode
Enable the Fibre Channel capability on an Aggregator for the
Fibre Channel protocol.
feature fc
CONFIGURATION
Creating a DCB Map
Congure the priority-based ow control (PFC) and enhanced trac selection (ETS) settings in a DCB map before you apply them
on downstream server-facing ports on an Aggregator.
Step
Task Command Command Mode
1
Create a DCB map to specify PFC and ETS settings for
groups of dot1p priorities.
dcb-map name
CONFIGURATION
2
Congure the PFC setting (on or o) and the ETS
bandwidth percentage allocated to trac in each priority
group. Congure whether the priority group trac should
priority-group
group_num {bandwidth
DCB MAP
252
NPIV Proxy Gateway