Administrator Guide
17
Stacking
An Aggregator auto-congures to operate in standalone mode. To use an Aggregator in a stack, you must manually congure it using
the CLI to operate in stacking mode.
Stacking is supported only on the 40GbE ports on the base module. Stacking is limited to six Aggregators in the same or dierent
m1000e chassis. To congure a stack, you must use the CLI.
Stacking provides a single point of management for high availability and higher throughput.
PMUX stacking allows the stacking of two or more IOA units. This allows grouping of multiple units for high availability. An
Aggregator supports a maximum of six stacking units.
NOTE: Prior to conguring the stack-group, ensure the stacking ports are connected and in 40G native mode.
Supported Modes
Standalone, PMUX, VLT, Stacking
Stacking Aggregators
A stack of Aggregators operates as a virtual chassis with management units (primary and standby) and member units. The Dell
Networking operating software elects a primary (master) and secondary (standby) management unit. The forwarding database
resides on the master switch; the standby unit maintains a synchronized local copy. Each unit in the stack makes forwarding
decisions based on their local copy.
The following example shows how you can stack two Aggregators. The Aggregators are connected to operate as a single stack in a
ring topology using only the 40GbE ports on the base modules.
Stacking
183