Administrator Guide

Multiple Uplink LAGs with 10G Member Ports
The following sample commands congure multiple dynamic uplink LAGs with 10G member ports based on LACP.
1. Bring up all the ports.
Dell#configure
Dell(conf)#int range tengigabitethernet 0/1 - 56
Dell(conf-if-range-te-0/1-56)#no shutdown
2. Associate the member ports into LAG-10 and 11.
Dell#configure
Dell(conf)#int range tengigabitethernet 0/41 - 42
Dell(conf-if-range-te-0/41-42)#port-channel-protocol lacp
Dell(conf-if-range-te-0/41-42-lacp)#port-channel 10 mode active
Dell(conf-if-range-te-0/41-42-lacp)#end
Dell#
Dell#configure
Dell(conf)#int tengigabitethernet 0/43
Dell(conf-if-te-0/43)#port-channel-protocol lacp
Dell(conf-if-te-0/43-lacp)#port-channel 11 mode active
Dell(conf-if-te-0/43-lacp)#end
Dell#
3. Show the LAG congurations and operational status.
Dell#show interface port-channel brief
Codes: L - LACP Port-channel
O - OpenFlow Controller Port-channel
LAG Mode Status Uptime Ports
L 10 L3 up 00:01:00 Te 0/41 (Up)
Te 0/42 (Up)
L 11 L3 up 00:00:01 Te 0/43 (Up)
Dell#
4. Congure the port mode, VLAN, and so forth on the port-channel.
Dell#configure
Dell(conf)#int port-channel 10
Dell(conf-if-po-10)#portmode hybrid
Dell(conf-if-po-10)#switchport
Dell(conf-if-po-10)#vlan tagged 1000
Dell(conf-if-po-10)#link-bundle-monitor enable
Dell#configure
Dell(conf)#int port-channel 11
Dell(conf-if-po-11)#portmode hybrid
Dell(conf-if-po-11)#switchport
Dell(conf-if-po-11)#vlan tagged 1000
% Error: Same VLAN cannot be added to more than one uplink port/LAG.
Dell(conf-if-po-11)#vlan tagged 1001
Dell(conf-if-po-11)#link-bundle-monitor enable
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port
Mirroring VLANs, P - Primary, C - Community, I - Isolated
O - Openflow
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
o - OpenFlow untagged, O - OpenFlow tagged
G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT
untagged, V - VLT tagged
NUM Status Description Q Ports
Link Aggregation
125