Administrator Guide

channel-member TenGigabitEthernet 0/8
shutdown
Dell(conf-if-po-3)#
Conguring the Minimum Oper Up Links in a Port Channel
You can congure the minimum links in a port channel (LAG) that must be in “oper up” status to consider the port channel to be in
“oper up” status.
To set the “oper up” status of your links, use the following command.
• Enter the number of links in a LAG that must be in “oper up” status.
INTERFACE mode
minimum-links number
The default is 1.
Example of Conguring the Minimum Oper Up Links in a Port Channel
Dell#config t
Dell(conf)#int po 1
Dell(conf-if-po-1)#minimum-links 5
Dell(conf-if-po-1)#
Conguring VLAN Tags for Member Interfaces
To congure and verify VLAN tags for individual members of a port channel, perform the following:
1. Congure VLAN membership on individual ports
INTERFACE mode
Dell(conf-if-te-0/2)#vlan tagged 2,3-4
2. Use the switchport command in INTERFACE mode to enable Layer 2 data transmissions through an individual interface
INTERFACE mode
Dell(conf-if-te-0/2)#switchport
This switchport conguration is allowed only in PMUX mode. In all other modes, it is automatically congured.
3. Verify the manually congured VLAN membership (show interfaces switchport interface command).
EXEC mode
Dell(conf)# interface tengigabitethernet 0/1
Dell(conf-if-te-0/1)#switchport
Dell(conf-if-te-0/1)# vlan tagged 2-5,100,4010
Dell#show interfaces switchport te 0/1
Codes: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Trunk, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged
Name: TenGigabitEthernet 0/1
802.1QTagged: True
Vlan membership:
Q Vlans
T 2-5,100,4010
Dell#
116
Link Aggregation