Users Guide

• 169 = SNMP
destination Enter the IP address of the network or host to which the packets
are sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or
non-contiguous.
count (OPTIONAL) Enter the keyword count to count packets the filter
processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
order (OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where 0 is
the highest priority and 254 is the lowest; lower-order numbers
have a higher priority) If you did not use the keyword order, the
ACLs have the lowest order by default (
255).
fragments Enter the keyword fragments to use ACLs to control packet
fragments.
threshold-in-
msgs count
(OPTIONAL) Enter the threshold-in-msgs keyword followed
by a value to indicate the maximum number of ACL logs that
can be generated, exceeding which the generation of ACL logs
is terminated with the seq, permit, or deny commands. The
threshold range is from 1 to 100.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default, flow-
based monitoring is not enabled.
Command Modes CONFIGURATION-IP ACCESS-LIST-EXTENDED
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added the support for flow-based monitoring on the MXL
10/40GbE Switch IO Module platforms.
9.3(0.0) Added the support for logging of ACLs on the MXL 10/40GbE
Switch IO Module platforms.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The order option is relevant in the context of the Policy QoS feature only. For more
information, refer to the Quality of Service chapter of the Dell Networking OS
Configuration Guide.
Access Control Lists (ACL) 252