Reference Guide

fcf-priority
In an FCoE map, configure the priority used by a server CNA to select an upstream FCoE forwarder (FCF).
Syntax
fcf—priority priority
Parameters
priority Enter the priority assigned to the FN 2210S Aggregator NPIV
proxy gateway, which appears to a downstream server CNA
as an FCF. The range of FCF priority values is from 1 to 255.
Defaults 128
Command
Modes
FCOE MAP
Supported
Modes
Programmable-Mux (PMUX)
Command
History
Version Description
9.6(0.0) Supported on the FN 2210S Aggregator.
9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module.
Usage
Information
The FCF priority you assign to an FN 2210S Aggregator is used by server CNAs to
select an upstream FCF to use for a fabric login (FLOGI).
To remove a configured FCF priority from an FCoE map, enter the no fcf-
priority command.
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the
communication between servers and a SAN fabric.
show fcoe-map displays the Fibre Channel and FCoE configuration parameters in
FCoE maps.
fc-map
In an FCoE map, configure the FCoE mapped address prefix (FC-MAP) value which is used to identify
FCoE traffic transmitted on the FCoE VLAN for the specified fabric.
Syntax
fc—map fc-map-value
Parameters
fc-map-value Enter the unique MAC address prefix used by a SAN fabric.
The range of FC-MAP values is from 0EFC00 to 0EFCFF.
285