Reference Guide

duplex half interface-
cong mode
Supported CLI not
available
CLI not available Invalid Input
error- CLI not
available
duplex full interface-
cong mode
Supported CLI not
available
CLI not available Invalid Input
error-CLI not
available
Viewing Interface Information
Displaying Non-Default Congurations.
The show [ip | running-config] interfaces configured command allows you to display only interfaces that have
non-default congurations are displayed.
The below example illustrates the possible show commands that have the available configured keyword.
Dell#show interfaces configured
Dell#show interfaces tengigabitEthernet 0 configured
Dell#show ip interface configured
Dell#show ip interface tengigabitEthernet 1 configured
Dell#show ip interface brief configured
Dell#show running-config interfaces configured
Dell#show running-config interface tengigabitEthernet 1 configured
In EXEC mode, show interfaces switchport command displays only interfaces in Layer 2 mode and their relevant
conguration information. The
show interfaces switchport command displays the interface, whether the interface
supports IEEE 802.1Q tagging or not, and the VLANs to which the interface belongs.
show interfaces switchport Command Example:
Dell#show interfaces switchport
Codes: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Trunk, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged
Name: TenGigabitEthernet 0/1
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
Name: TenGigabitEthernet 0/2
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
Name: TenGigabitEthernet 0/3
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
Name: TenGigabitEthernet 0/4
802.1QTagged: False
Interfaces
99