Reference Guide

G - GVRP tagged, M - Trunk, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged
Name: TenGigabitEthernet 0/1
802.1QTagged: Hybrid
SMUX port mode: Admin VLANs enabled
Vlan membership:
Q Vlans
U 1
T 2-5,100,4010
Native VlanId: 1
Software show Commands
Use the show version and show system stack-unit 0 commands as a part of troubleshooting an Aggregator’s software
conguration.
Table 37. Software show Commands
Command Description
show version Display the current version of Dell Networking OS software running on an
Aggregator.
show version Command Example
Dell#show version
Dell Real Time Operating System Software
Dell Operating System Version: 2.0
Dell Application Software Version: 9-4(0-180)
Copyright (c) 1999-2014 by Dell Inc. All Rights Reserved.
Build Time: Sun Mar 30 20:15:19 PDT 2014
Build Path: /work.local/build/toolSpaces/tools05/E9-4-0/SW/SRC
Dell Networking OS uptime is 9 hour(s), 21 minute(s)
System image file is "dv-ci-stomp-tc-1-a1"
System Type: PE-FN-410S-IOA
Control Processor: MIPS RMI XLP with 2147483648 bytes of memory, core(s) 1.
128M bytes of boot flash memory.
1 12-port GE/TE (FN)
12 Ten GigabitEthernet/IEEE 802.3 interface(s)
Dell#
Oine Diagnostics
The oine diagnostics test suite is useful for isolating faults and debugging hardware.
The diagnostics tests are grouped into three levels:
• Level 0 — Level 0 diagnostics check for the presence of various components and perform essential path verications. In
addition, Level 0 diagnostics verify the identication registers of the components on the board.
• Level 1 — A smaller set of diagnostic tests. Level 1 diagnostics perform status, self-test, access, and read-write tests for all the
components on the board and test their registers for appropriate values. In addition, Level 1 diagnostics perform extensive tests
on memory devices (for example, SDRAM, ash, NVRAM, EEPROM) wherever possible.
• Level 2 — The full set of diagnostic tests. Level 2 diagnostics are used primarily for on-board MAC level, Physical level, external
Loopback tests, and more extensive component diagnostics. Various components on the board are put into Loopback mode and
test packets are transmitted through those components. These diagnostics also perform snake tests using virtual local area
network (VLAN) congurations.
236
Debugging and Diagnostics