Reference Guide

Vlan membership:
Q Vlans
U 1
--More--
Clearing Interface Counters
The counters in the show interfaces command are reset by the clear counters command. This command does not clear
the counters captured by any SNMP program.
To clear the counters, use the following command in EXEC Privilege mode:
Command Syntax Command Mode Purpose
clear counters [interface] EXEC Privilege Clear the counters used in the show interface commands for all VLANs,
and physical interfaces or selected ones.
Without an interface specied, the command clears all interface
counters.
• (OPTIONAL) Enter the following interface keywords and slot/port or
number information:
• For a Port Channel interface, enter the keyword port-channel
followed by a number from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port numbers.
• For a VLAN, enter the keyword vlan followed by a number from 1 to
4094.
When you enter this command, you must conrm that you want Dell Networking OS to clear the interface counters for the interface
(refer to the below clearing interface example).
Clearing an Interface:
Dell#clear counters tengig 0/1
Clear counters on TenGigabitEthernet 0/1 [confirm]
Dell#
Fibre Channel Interface
The FN 2210S functions as a converged enhanced Ethernet (CEE) switch that supports both LAN and storage area network (SAN)
trac using the Fibre Channel protocol.
To access a SAN fabric, use a Fibre Channel (FC) module installed in the aggregator.
Conguring Fibre Channel Interfaces
To congure FC interfaces on the FN 2210S aggregator, follow these steps.
1. Enable Fibre Channel capability on the switch.
2. Congure Fibre Channel interfaces.
3. Verify the global Fibre Channel conguration on the switch and on individual interfaces.
Enabling Fibre Channel Capability
To enable Fibre Channel capability, follow this step.
Enable Fibre Channel capability.
CONFIGURATION mode
100
Interfaces