Reference Guide

keyword unit then 0 for port-pipe 0, then port and the port number (42-53,
and then buffer-info.
cpu {data-plane
statistics |
management
statistics | private-
mgmt statistics}
Enter the keyword cpu then one of the keywords to display the CPU statistics:
data-plane statistics, management statistics, or private-mgmt
statistics
.
drops interface
interface
Enter the keyword drops to display internal drops on the selected stack member.
fpga registers Enter the keywords fpga registers to display fpga details.
fru dump Enter the keywords fru dump to display fru details.
stack-port 9-12 Enter the keywords stack-port and a stacking port number to select a stacking
port for which to display statistics. Identify the stack port number as you would to
identify a 10G port that was in the same place in one of the rear modules.
NOTE: You can identify stack port numbers by physical inspection of the
rear modules. The numbering is the same as for the 10G ports. You can also
inspect the output of the
show system stack-ports command.
unit 0-0 {counters |
details | ipmc-
replication | port-
stats [detail] |
register | table-
dump WORD}}
Enter the keyword unit then 0 for port-pipe 0, and then enter one of the
following keywords to troubleshoot errors on the selected port-pipe and to give
status on why a port is not coming up to register level: counters, details,
ipmc-replication, port-stats [detail], register, or table-dump
WORD.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.8(0.0) Replaced the keyword port with interface.
9.4(0.0) Supported on the FN I/O Aggregator.
Example (data-
plane)
Dell#show hardware stack-unit 0 cpu data-plane statistics
bc pci driver statistics for device:
rxHandle :9798
noMhdr :0
noMbuf :0
noClus :0
recvd :9798
dropped :0
recvToNet :9778
rxError :0
rxDatapathErr :0
rxPkt(COS0) :0
rxPkt(COS1) :0
rxPkt(COS2) :25
rxPkt(COS3) :0
rxPkt(COS4) :0
340