Reference Guide

show running-cong monitor session
Displays the running conguration of all monitor sessions or a specic session.
Syntax
show running-config monitor session {session-ID}
To display the running conguration for all monitor sessions, use the show running-config monitor
session command.
Parameters
session-ID (OPTIONAL) Enter a session identication number. The range is from 0 to 65535.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
Usage Information The monitoring command is saved in the running conguration at the Monitor Session mode level and
can be restored after a chassis reload.
Example
Dell#show run monitor session
!
monitor session 5
source TenGigabitEthernet 0/4 destination TenGigabitEthernet 0/5 direction
rx
!
monitor session 20
source TenGigabitEthernet 0/3 destination TenGigabitEthernet 0/2 direction
both
Dell#
Dell#show run monitor session 20
!
monitor session 20
source TenGigabitEthernet 0/3 destination TenGigabitEthernet 0/2 direction
both
Dell#
Related Commands
monitor session — creates a session for monitoring.
show monitor session — displays a monitor session.
source (port monitoring)
Congure a port monitor source.
Syntax
source interface destination interface direction {rx | tx | both}
To disable a monitor source, use the no source interface destination interface
direction {rx | tx | both} command.
Parameters
interface Enter the one of the following keywords and slot/port information:
255