Reference Guide

ManualsBrandsDell ManualsComputer HardwarePowerEdge FX2/FX2s

241

242

243

244

245

246

247

248

249

250

Usage Information

Use the show fcoe-map command to display the FC and FCoE parameters used to congure server-

facing Ethernet (FCoE) and fabric-facing FC ports in all FCoE maps on an FN 2210S Aggregator with the

FC Flex IO module NPIV proxy gateway.

In each FCoE map, the values for the fabric ID and FC-MAP that identify the SAN fabric to which FC

storage trac is sent, and the FCoE VLAN to be used must be unique.

The following table describes the show fcoe-map brief output shown in the example below.

Field Description

Fabric-Name Name of a SAN fabric.

Fabric ID The ID number of the SAN fabric to which FC trac is forwarded.

VLAN ID The dedicated FCoE VLAN used to transport FCoE storage trac between servers

and a fabric over the NPIV proxy gateway. The congured VLAN ID must be the

same as the fabric ID.

FC-MAP FCoE MAC address-prex value - The unique 24-bit MAC address prex that

identies a fabric.

FCF Priority The priority used by a server to select an upstream FCoE forwarder.

Cong-State Indicates whether the congured FCoE and FC parameters in the FCoE map are

valid: Active (all mandatory FCoE and FC parameters are correctly congured) or

Incomplete (either the FC-MAP value, fabric ID, or VLAN ID are not correctly

congured).

Oper-State Operational status of link to the fabric: Up (link is up and transmitting FC trac),

Down (link is down and not transmitting FC trac), Link-wait (link is up and waiting

for FLOGI to complete on peer FC port), or Removed (port has been shut down).

The following table describes the show fcoe-map map-name output shown in the example below.