Reference Guide
dcb-map stack-unit all stack-ports all– applies a DCB map on all ports of a switch stack.
description (for FCoE maps)
In an FCoE map, add a text description of the FCoE and FC parameters used to transmit storage trac over an FN 2210S
Aggregator and M I/O Aggregator NPIV proxy gateway in a converged fabric.
Syntax
description text
Parameters
text Enter a maximum of 32 characters.
Defaults None
Command Modes FCOE MAP
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.6(0.0) Supported on the FN 2210S Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
Usage Information
The text description is displayed in show fcoe-map command output.
Related Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between
servers and a SAN fabric.
show fcoe-map— displays the Fibre Channel and FCoE conguration parameters in FCoE maps.
fabric-id vlan
In an FCoE map, congure the association between the dedicated VLAN used to carry FCoE trac between servers and a SAN, and
the fabric where the desired storage arrays are installed.
Syntax
fabric-id fabric-num vlan vlan-id
Parameters
fabric-id fabric-num Enter a fabric ID number that is the same as the ID number of the dedicated VLAN
used to carry FCoE storage trac to the fabric specied in the FCoE map. You can
enter a fabric ID in the range 2–4094.
vlanvlan-id Enter the ID number of the dedicated VLAN used to carry FCoE storage trac
between servers and a SAN fabric and specied with the vlan command in the
FCoE map.
Defaults None
Command Modes FCOE MAP
Supported Modes Programmable-Mux (PMUX)
239