Reference Guide

detail (OPTIONAL) Enter the keyword detail to display detailed packet information.
tx (OPTIONAL) Enter the keyword tx to display transmit-only packet information.
rx (OPTIONAL) Enter the keyword rx to display receive-only packet information.
both (OPTIONAL) Enter the keyword both to display both receive and transmit packet
information.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
disable
Enable or disable LLDP.
Syntax
disable
To enable LLDP, use the no disable command.
Defaults Enabled, that is no disable.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
debug lldp interface — debugs LLDP.
hello
Congure the rate at which the LLDP control packets are sent to its peer.
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
234