Reference Guide

When you congure a speed for the 1000/10000 interface, conrm the negotiation auto command
setting. Both sides of the link must should have auto-negotiation either enabled or disabled. For speed
settings of 1000 or auto, the software sets the link to auto-negotiation and you cannot change that setting.
Related Commands
negotiation auto — enables or disables auto-negotiation on an interface.
stack-unit port-group port mode ethernet
Converts the interfaces 9 and 10 from Fibre Channel mode to Ethernet.
Syntax
stack-unit unit number port-group 0 portmode ethernet
To convert the interfaces 9 and 10 from Ethernet to Fibre Channel mode, use the no stack-unit unit
number port-group 0 portmode ethernet.
Parameters
stack-unit Enter the keyword stack-unit followed by a stack member number to select
the stack unit. The range is 0 to 5.
port-group Enter the keyword port-group followed by 0.
portmode ethernet Enter the keyword portmode ethernet to convert the interfaces from Fibre
Channel mode to Ethernet.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.6(0.0) Supported on the FN2210S Aggregator.
tdr-cable-test
Test the condition of copper cables on 100/1000/10GBase-T modules.
Syntax
tdr-cable-test interface
Parameters
interface Enter the keyword TenGigabitEthernet followed by the slot/port information
for the 100/1000/10GBase-T Ethernet interface.
Defaults none
Command Modes EXEC
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
186