Reference Guide

Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell(conf-lldp)#show conf
!
protocol lldp
Dell(conf-lldp)#
show interfaces
Displays information on a specic physical interface or virtual interface.
Syntax
show interfaces interface
Parameters
interface Enter one of the following keywords and slot/port or number information:
• For the management interface on the stack-unit, enter the keyword
managementethernet followed by slot/port information. The slot and port
range is 0.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan followed by a number from 1 to
4094.
• For a Port Channel interface, enter the keyword port-channel followed by a
number. The range is from 1 to 128.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
Usage Information
Use this show interfaces command for details on a specic interface. Use the show interfaces
stack-unit command for details on all interfaces on the designated stack unit.
On the I/O Aggregator, the show interface output displays incorrect rate information details over time for
link monitoring when the rate-interval is congured for 5 seconds. Dell Networking recommends using higher
rate-intervals such as 15 to 299 seconds to minimize the errors seen.
NOTE: In the CLI output, the power value will be rounded to a 3-digit value. For receive/transmit
power that is less than 0.000, an snmp query will return the corresponding dbm value even though
the CLI displays as 0.000.
NOTE: After the counters are cleared, the line-rate continues to increase until it reaches the
maximum line rate. When the maximum line rate is reached, there will be no change in the line-rate.
172