Reference Guide

Example-Bulk
Conguration
Warning Message
Dell(conf)#interface range tengig 0/1 - 2 , tengig 0/4 , tengig 0/7
, fa 0/0
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example-Interface
Range prompt with
Multiple Ports
Dell(conf)#interface range tengig 0/1 - 2 , tengig 0/3 - 5
Dell(conf-if-range-te-0/1-5)#
Example-Interface
Range prompt
Overlapping Port
Ranges
Dell(conf)#interface range tengig 0/1 - 2 , tengig 0/1 - 5
Dell(conf-if-range-te-0/1-5)#
Only VLAN and port-channel interfaces created using the interface vlan and vlan tagged
commands can be used in the interface range command.
Use the show running-config command to display the VLAN and port-channel interfaces. VLAN or
port-channel interfaces that are not displayed in the
show running-config command cannot be used
with the bulk conguration feature of the interface range command. You cannot create virtual
interfaces (VLAN, Port-channel) using the interface range command.
NOTE: If a range has VLAN, physical, and port-channel interfaces, only commands related to
physical interfaces can be bulk congured. To congure commands specic to VLAN or port-
channel, only those respective interfaces should be congured in a particular range.
Example-Single
Range Bulk
Conguration
Dell(conf)# interface range tengigabitethernet 0/1 - 5
Dell(conf-if-range-te-0/1-5)# no shutdown
Dell(conf-if-range-te-0/1-5)#
Example-Multiple
Range Bulk
Conguration with
VLAN and port
channel
The following example shows how to use commas to add VLAN and port-channel interfaces to the range.
Dell(conf-if)# interface range tengigabitethernet 0/1 - 5, vlan 2 - 10,
port-channel 1 - 25
Dell(conf-if-range-te-0/1-5,vl-2-10,po-1-25)# no shutdown
Dell(conf-if-range-te-0/1-5,vl-2-10,po-1-25)#
Related commands show cong (from INTERFACE RANGE mode) — Shows the bulk conguration interfaces.
show interfaces status — Displays a summary of interface information.
interface vlan
Congure a VLAN. Congure the default VLAN to enable Static or DCHP IP conguration. You can congure up to 4094 VLANs.
Syntax
interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
Parameters
vlan-id Enter 1 for the default VLAN. Enter a number as the VLAN identier. The range is
from 1 to 4096.
Defaults Not congured, except for the default VLAN, which is congured as VLAN 1.
Command Modes CONFIGURATION
Supported Modes All Modes
162