Reference Guide

ip igmp snooping mrouter
Statically congure a VLAN member port as a multicast router interface.
Syntax
ip igmp snooping mrouter interface interface
To delete a specic multicast router interface, use the no igmp snooping mrouter interface
interface command.
Parameters
interface interface Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
Defaults Not congured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
Usage Information Dell Networking OS provides the capability of statically conguring the interface to which a multicast router
is attached. To congure a static connection to the multicast router, enter the ip igmp snooping
mrouter interface command in the VLAN context. The interface to the router must be a part of the
VLAN where you are entering the command.
ip igmp snooping querier
Enable IGMP querier processing for the VLAN interface.
Syntax
ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, use the no ip igmp snooping querier
command.
Defaults Not congured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information This command enables the IGMP switch to send General Queries periodically. This behavior is useful when
there is no multicast router present in the VLAN because the multicast trac is not routed. Assign an IP
address to the VLAN interface for the switch to act as a querier for this VLAN.
147