Personal Computer User Manual
Table Of Contents
- Hardware Owner’s Manual
- Contents
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Removing and Replacing the Optional Front Bezel
- Opening and Closing the System
- Cooling Fans
- Cooling Shrouds
- Power Supplies
- Expansion Cards
- RAC Card
- System Memory
- Processors
- Processor VRMs
- Installing a Diskette Drive
- Installing an Optical Drive
- Hard Drives
- SAS Controller Cards
- Connecting an External SAS Tape Drive
- Connecting an External Fibre Channel Storage Device
- System Battery
- Control Panel Assembly (Service-Only Procedure)
- Fan Interposer Board (Service-Only Procedure)
- Power Distribution Board (Service-Only Procedure)
- Chassis Intrusion Switch (Service-Only Procedure)
- SAS Backplane (Service-Only Procedure)
- System Board (Service-Only Procedure)
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking Basic Power Problems
- Checking the Equipment
- Troubleshooting Serial I/O Problems
- Troubleshooting a NIC
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting Power Supplies
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting a Diskette Drive
- Troubleshooting an Optical Drive
- Troubleshooting a Hard Drive
- Troubleshooting a SAS Controller or SAS RAID Controller
- Troubleshooting an External SAS Tape Drive
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessors
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
68 Installing System Components
3
Remove the top cooling shroud. See "Removing the Cooling Shrouds" on page 49.
4
Locate the VRM sockets. See Figure 6-2.
5
Press down and out on the ejectors on each end of the socket and lift the VRM out of the socket. See
Figure 3-13.
Installing a Diskette Drive
1
Turn off the system, including any attached peripherals, and disconnect the system from the electrical
outlet.
2
Remove the front bezel, if attached. See"Removing and Replacing the Optional Front Bezel" on
page 45.
3
To remove the drive carrier, pull the release latch forward, then slide the carrier out of the chassis. See
Figure 3-14
.
Figure 3-14. Removing and Installing the Diskette/Optical Drive Carrier
4
Remove the optical drive or optical drive filler plate from the carrier:
a
Loosen the thumbscrew on the latch securing the optical drive or filler plate. See Figure 3-15.
b
Remove the latch.
c
Lift the optical drive or optical drive filler plate from the carrier.
1 release latch 2 diskette/optical drive carrier
2
1