Server Hardware Owner's Manual
Table Of Contents
- Contents
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Front Drive Bezel
- Opening the System
- Closing the System
- Removing and Installing Blank Drive EMI Fillers
- Cooling Shrouds
- Power Supplies
- Hard Drives
- Diskette Drive
- Optical and Tape Drives
- Expansion Cards
- SAS Controller Card
- RAID Battery
- Configuring the Boot Device
- RAC Card
- Internal USB Memory Key Connector
- Integrated TOE
- Cooling Fans
- System Memory
- Processors
- System Battery
- Chassis Intrusion Switch
- Power Supply Distribution Board
- SAS/SATA Backplane
- Control Panel (Service-only Procedure)
- System Board (Service Only Procedure)
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Troubleshooting Serial I/O Problems
- Troubleshooting a NIC
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting Redundant Power Supplies
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting an Internal USB Key
- Troubleshooting a Diskette Drive
- Troubleshooting an Optical Drive
- Troubleshooting a SCSI Tape Drive
- Troubleshooting a Hard Drive
- Troubleshooting a Hot-plug Hard Drive
- Troubleshooting a SAS or SAS RAID Controller
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessors
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
Installing System Components 79
• Tape backup unit
• Optical drives
6
Remove the two screws that secure the power supply to the system. See
Figure 3-8.
7
Press the power supply release tab, and slide the power supply out from the
back of the system. See Figure 3-8.
8
If you plan to replace a non-redundant power supply with redundant power
supplies, you will need to replace the power supply cage cover with the
power supply distribution board and its shroud.
a
Remove the power supply cage cover by pulling the blue release pins
until they unlock from the power supply cage, and lift the cover out of
the chassis. See Figure 3-41.
b
Install the power supply distribution board and its shroud. See
"Installing the Power Supply Distribution Board" on page 147.