Server Hardware Owner's Manual
Table Of Contents
- Contents
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Front Drive Bezel
- Opening the System
- Closing the System
- Removing and Installing Blank Drive EMI Fillers
- Cooling Shrouds
- Power Supplies
- Hard Drives
- Diskette Drive
- Optical and Tape Drives
- Expansion Cards
- SAS Controller Card
- RAID Battery
- Configuring the Boot Device
- RAC Card
- Internal USB Memory Key Connector
- Integrated TOE
- Cooling Fans
- System Memory
- Processors
- System Battery
- Chassis Intrusion Switch
- Power Supply Distribution Board
- SAS/SATA Backplane
- Control Panel (Service-only Procedure)
- System Board (Service Only Procedure)
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Troubleshooting Serial I/O Problems
- Troubleshooting a NIC
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting Redundant Power Supplies
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting an Internal USB Key
- Troubleshooting a Diskette Drive
- Troubleshooting an Optical Drive
- Troubleshooting a SCSI Tape Drive
- Troubleshooting a Hard Drive
- Troubleshooting a Hot-plug Hard Drive
- Troubleshooting a SAS or SAS RAID Controller
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessors
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
Installing System Components 71
Removing and Installing Blank Drive EMI Fillers
Depending on the configuration of your system, a blank drive EMI filler
might be installed in place of an optical or diskette drive. These are essential
for airflow efficiency and for electromagnetic interference (EMI) protection.
You must remove the blank drive EMI filler if you decide to replace it with an
optional diskette or optical drive. Squeeze the filler tabs, and pull the filler
out of the chassis. See Figure 3-5.
To replace the blank drive EMI filler, push the filler into the slot on the
chassis until the filler tabs lock into place.
Figure 3-5. Removing and Installing a Blank Drive EMI Filler
1 filler tabs 2 blank drive EMI filler
2
1